Manufacturing monitoring, in plain terms
The vocabulary that comes up in every machine-monitoring conversation, without the marketing.
- OEE
- Overall Equipment Effectiveness. Availability × Performance × Quality, expressed as a percentage. Useful as a trend, misleading as a single number, because it hides which of the three components moved.
- Availability
- The share of planned production time the machine was actually running.
- Performance
- How close the machine ran to its ideal cycle time while it was running.
- Quality
- The share of parts produced that were good first time.
- Cycle time
- The time to produce one part, measured machine-side rather than estimated.
- Takt time
- The production rate required to meet customer demand.
- Downtime reason code
- A short agreed label for why a machine stopped. The value comes from everyone using the same list.
- Minor stop
- A short stoppage, often under five minutes, usually uncounted and collectively expensive.
- MTBF
- Mean time between failures. How long equipment typically runs before it fails.
- MTTR
- Mean time to repair. How long it typically takes to get it running again.
- MTConnect
- An open standard for reading data from manufacturing equipment.
- OPC UA
- An industrial communication standard widely supported by modern controls and PLCs.
- FOCAS
- The interface used to read data from Fanuc CNC controls.
- Edge gateway
- Hardware or software inside the plant that collects machine data locally before sending it on.
- OT and IT
- Operational technology is the plant floor network. Information technology is the business network. Keeping them separated is a security requirement at most sites.
